, , ,

Case Fan & heatsink for Raspberry Pi 4 Case

Availability:

Out of stock


Fitting instructions

1 Remove any SD card, then put your Raspberry Pi into the lower half (base)
of the case. Take care to align the mounting holes in the corners with the
bumps in the case.
2 Insert the fan into the upper half (lid) of the case, with the green label facing
away from the lid. Push gently but firmly so that the two tabs on the fan
housing click neatly into place inside the tabs on the lid. The slightly curved
edge of the housing should be flush with the underside of the lid.
3 If you are also fitting the heatsink, remove the backing paper from the
self-adhesive pad on the base of the heatsink, position it centrally over the
processor, and gently press it into position.
4 Connect the three leads from the fan to the Raspberry Pi 4?s GPIO pins, as
shown in the table and diagram below. Take care to connect each lead to the
correct pin.
Lead Colour GPIO pin
5v RED 4
Ground BLACK 6
GPIO 14 BLUE 8
5 Fit the lid of the case onto the base.

WARNINGS
? This product should only be used in conjunction with Raspberry Pi 4 Model B and the official Raspberry
Pi 4 Case.
? This product should be operated in a well-ventilated environment and the case should not be covered.
SAFETY INSTRUCTIONS
To avoid malfunction or damage to this product, please observe the following:
? Do not expose to water or moisture, or place on a conductive surface whilst in operation.
? Do not expose to heat from any external source; the Raspberry Pi Case Fan is designed for reliable
operation at normal ambient temperatures.
? Take care whilst handling to avoid mechanical or electrical damage to the fan and connectors.
? Avoid handling the fan whilst it is powered.

12,900

Out of stock

The Raspberry Pi 4 Case Fan is an official accessory for Raspberry Pi 4, for
use with the official Raspberry Pi 4 Case. Designed for over-clockers and
other power users, it keeps your Raspberry Pi 4 at a comfortable operating
temperature even under heavy load.

Features

Specification

Input voltage: 5V DC supplied via 40-pin GPIO header on Raspberry

Pi 4

Fan speed control: Pulse width modulation control via user-selectable

GPIO pin
Maximum airflow: 1.4 CFM
Case material: Clear PC
Compliance: For a full list of local and regional product approvals,

please visit

www.raspberrypi.org/documentation/hardware/

raspberrypi/conformity.md
? Fits perfectly into the lid of the Raspberry Pi 4 Case
? Temperature-controlled fan delivers up to 1.4 CFM of air flow over the
processor, memory, and power management IC
? 18 mm ? 18 mm ? 10 mm heatsink with self-adhesive pad improves heat
transfer from the processor

Specification

Input voltage: 5V DC supplied via 40-pin GPIO header on Raspberry

Pi 4

Fan speed control: Pulse width modulation control via user-selectable

GPIO pin
Maximum airflow: 1.4 CFM
Case material: Clear PC
Compliance: For a full list of local and regional product approvals,

please visit

www.raspberrypi.org/documentation/hardware/

raspberrypi/conformity.md

Weight0.2 kg
Dimensions1.8 × 1.8 × 1 cm